MIL-PRF-24792A
6.3.2 Alternate forms of conformance inspection. Requests for
alternate forms of conformance inspection must be submitted to the contracting
officer. Alternate forms of quality conformance inspection may be used upon
written approval by the contracting officer.
6.4 Definitions. Definitions of terms should be in accordance with
TIA/EIA-440 and the following subparagraphs.
6.4.1 First contract. The first contract is considered to be the first
contract under which a manufacturer's material is supplied to any acquiring
activity under this specification.
6.4.2 First contract inspection. First contract inspections are
inspections required in addition to first article inspections for the first
contract in which this specification is invoked. First contract inspections
are intended to evaluate basic material properties that are primarily a
function of the product formulation, not the product manufacturing process.
6.5 Part or identifying number (PIN). The PIN for this adhesive should
consist of the basic specification number, a one character cure schedule
identifier, and an optional space flight application identifier as shown in
the following example:
M24792 A S
Base specification number
Cure schedule identifier (see table VIII)
Space flight application
TABLE VIII.
Cure schedule identifiers.
Cure schedule identifier
Cure schedule
A
10 ±1 minutes at +120 °C ± 3 °C
B
10 ±1 minutes at +100 °C ± 3 °C
C
2 ±1 minutes at +25 °C ± 3 °C
6.6 Shelf life. Products acquired to this specification should not be
used for fiber optic termination purposes, under any conditions, if the date
of manufacture has passed by more than 24 months. If products acquired to
this specification are exposed to temperatures higher than the temperatures
specified in 3.4.2, the shelf life may be decreased, and the manufacturer
should be contacted to determine the appropriate shelf life under the actual
storage conditions. Storage conditions should never exceed the temperature
specified in 4.6.2.
6.7 Material safety data sheet (MSDS). The adhesive covered by this
specification contains material(s) which may be hazardous to personnel. A
material safety data sheet (MSDS) is needed for employee safety programs.
Contracting officers will identify those activities requiring copies of
completed MSDSs, prepared in accordance with FED-STD-313. In order to obtain
the MSDS, Federal Acquisition Regulations (FAR) clause 52.223-3 must be in the
contract.
6.8
Conformance inspection.
6.8.1 Rejected lots. If a group B inspection lot is rejected, the
contractor may rework it to correct the defects, or screen out the defective
units (if applicable), and resubmit the lot for inspection.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business